Skip to content
Contact Us
  • There are no suggestions because the search field is empty.

Wall Storage Mounting Instructions (2025)

Starting in 2025, the Wall Storage includes three panels. If you purchased your Wall Storage prior to 2025, please refer to these installation instructions.

Required Materials

Included with your Wall Storage

  • 3 Wall Panels

  • 45 Bins (20 Large and 25 Small)

  • Bin Labels

Not Included (Needed for Installation)

  • Wall Anchors x 12

  • 1 ¼” - 1 ½“ Screws x 12

  • Countersunk Washers x 12

  • Pencil

  • Screwdriver

  • Ruler

  • Level

  • Tape Measure

Prepare for Installation

Location

  • Mount your Wall Storage in an open, visible area, not in a corner or behind other tools.

  • For younger users, keep the area beneath the storage free of desks or shelving to make bins easily accessible.

Surface & Anchor Selection

  • Ensure the surface can support the panels and the maximum load of Bits.

  • Use anchors unless mounting to ¾” thick plywood.

  • Plastic anchors work well for drywall.

Height

  • Adults: top of panels between 75"–78" (190–198 cm).

  • Children: top of panels between 55"–64" (140–162 cm).

Install the Panels

  1. Enlist a friend – installation is easier with two people.

  2. Decide the maximum height and mark the top left pilot hole with a pencil.

  3. For drywall: drill a hole for your wall anchor using a screwdriver or drill slightly smaller than the anchor.

  4. Mark the next pilot hole 16" to the right, using a ruler and level, and drill the hole.

  5. Insert wall anchors into all drilled holes.

  6. Align the top edge of the panel with the pilot holes and mark the lower holes. Drill and insert anchors.

  7. Screw the panel in place using washers and screws.

  8. Place the next panel next to the first. Repeat the steps for drilling, anchoring, and screwing.

  9. Repeat for the remaining panels.

Add Bins and Labels

  1. Hook the bins into the indented areas on the wall panels.

  2. Slide-in bin labels on the front of the bins.

  3. Organize Bits in columns by function (Power, Input, Wire, Output, Accessories).

  4. Arrange modules in ascending order by identifying number (e.g., i11, i12, i13).

Add Bits

  • Place Bits and accessories into the corresponding bins.

Get Started